McClave Builders Blog

Planning a Bathroom Remodel: What Matters Behind the Walls

November 13, 2026

Most bathroom remodels start with tile samples and vanity photos. That’s the fun part, and it matters. But the bathrooms that fail, the ones with soft floors, peeling paint, and a musty smell five years later, almost never fail because of the finishes. They fail because of what happened behind the walls and under the floor.

If you’re planning a bathroom remodel this winter, here’s what to get right before anyone talks about grout color.

Start With What’s Already There

Before you design anything, find out what you’re working with. In older homes across Chester and Montgomery Counties, a bathroom may have been remodeled two or three times over the decades, and each round tends to leave something behind: tile set over old tile, a subfloor patched with whatever was on hand, or a vent fan that dumps into the attic.

Things worth checking early:

  • Soft spots or movement in the floor, especially around the toilet and tub
  • Water stains on the ceiling below the bathroom
  • Where the exhaust fan actually terminates (outside, or into the attic)
  • The type and age of the drain and supply lines, if you can see them from a basement or access panel
  • Whether the room has a dedicated circuit and GFCI protection

You won’t know everything until demolition. But a good contractor will walk the room, look from the basement or crawlspace, and tell you where the likely surprises are before you sign anything. That’s a core part of a structured preconstruction process: identifying risk while it’s still cheap to plan around.

Decide Early Whether Fixtures Move

The single biggest layout decision is whether the toilet, shower, tub, and vanity stay where they are. Keeping fixtures in place usually keeps plumbing work simpler. Moving them can mean rerouting drains, cutting into joists, adding vents, and opening ceilings below.

Sometimes moving a fixture is absolutely worth it, like turning an awkward tub alcove into a walk-in shower or getting the toilet out of the line of sight from the door. Just make that decision at the start, not after demo, because it drives the plumbing scope, the framing, and the schedule. Costs vary widely with scope and finishes, and relocation is one of the factors that moves the number most.

Waterproofing Is Not Optional

Tile and grout are not waterproof. Grout is porous, and water will find its way behind tile over time. What keeps the framing dry is the layer underneath. In a tiled shower, that means a properly built shower system:

  • A sloped shower floor so water drains to the drain instead of sitting under the tile
  • A continuous waterproof membrane on the floor and walls, either a sheet or a liquid-applied system, tied into the drain
  • Sealed seams, corners, niches, and penetrations where valves and shower heads come through the wall
  • A flood test on the pan before tile goes down, so a leak is found when it’s easy to fix

Ask any contractor you’re considering exactly how they waterproof a shower and whether they flood test. A clear, specific answer is a good sign. A vague one is a red flag.

Ventilation That Actually Works

Southeastern PA winters are hard on bathrooms. Warm, wet air hits cold exterior walls and ceilings, and if it isn’t removed, it condenses. That’s how you get peeling paint, mildew on the ceiling, and in the worst cases, damp insulation and framing.

  • Vent the fan to the outdoors, not into the attic or a soffit where moist air can get pulled back in
  • Size the fan to the room; a common rule of thumb for smaller bathrooms is about one CFM per square foot of floor area, with more for larger rooms or separate shower enclosures
  • Use insulated, short, straight duct runs so the fan performs close to its rating
  • Consider a humidity-sensing switch or timer so the fan keeps running after the shower is off

Venting requirements are set by code, and your township’s inspector will look at them. Confirm the specifics with your township before work starts.

Don’t Forget the Floor Structure

Tile, especially large-format tile and natural stone, needs a stiff floor. If the joists flex, grout cracks and tiles pop loose. Older bathrooms often have joists that were notched for drain lines decades ago, or subfloors weakened by slow leaks around the toilet.

Once the floor is open, it’s the right time to sister damaged joists, replace rotted subfloor, and install a proper tile underlayment. A heavy cast iron or stone tub may also need added support. This is carpentry work that never shows in the finished photos, and it’s what keeps the finished room solid for decades.

Plan Electrical and Lighting With the Layout

Bathroom lighting is often an afterthought, and it shows. A single ceiling fixture casts shadows on your face at the mirror. Plan lighting in layers:

  • Task lighting at the mirror, ideally on both sides or directly above
  • A wet-rated fixture in or over the shower
  • General ceiling lighting for the room
  • Outlets placed where you’ll actually use a hair dryer or toothbrush charger, with GFCI protection

If you want heated floors, decide before the floor is built. The heating mat goes under the tile and needs its own circuit and thermostat location.

Lock In Selections Before Demo

Valves, drains, vanities, and tile sizes all affect rough-in. A wall-mounted faucet, a linear drain, or a curbless shower each need specific framing and plumbing decisions made before walls close. Having fixtures chosen, and ideally on site, before demolition keeps the job from stalling halfway through while a crew waits on a part.

Why Winter Is a Good Time to Remodel a Bathroom

Bathrooms are interior work, so weather rarely slows them down. Planning one over the winter also means decisions get made without the pressure of a spring rush. If you have more than one bathroom, it’s a manageable project to live through. If it’s your only full bath, talk with your contractor about sequencing so you’re without a shower for as little time as possible.

Talk Through Your Bathroom Project

McClave Builders handles bathroom remodels throughout Chester and Montgomery Counties, from Pottstown and Royersford to Phoenixville and West Chester. Our carpentry is done in-house, our pricing is transparent cost-plus, and every project starts with a structured preconstruction process so the hidden work is planned, not discovered. See our remodel and renovation services, browse our portfolio, or check our service areas.

Ready to start planning? Contact us or call (610) 300-5585.